Message Board Thread - "Duplicating a page on the report"

Back to Threads | Back to Forums

TitleByPosted On
Duplicating a page on the report Brimstone 2/22/2005
To do the IR reports I am using the software that is incorporated with Word. Sometimes one single image has more than one hot spot (a breaker might have two loose connections). If I forget to upload the image twice, is there a way to duplicate that page once at the report?

I tried highlighting the whole page, then copying it and then pasting it, but the reference temperature is fixed on the hottest spot and does not allow to change it (it allows to change the spot marks but the actual temperature readings do not change).

Thanks in advance
 
Re:Duplicating a page on the report jgagnon 2/22/2005
There is an analysis toolbar in Word that allows you to add several spots, areas, lines, etc. to an IR image. You can simply click on the spot button and then click on the IR image where you want the spot to appear. All temperature results can be shown in a results table. This is much easier than adding a second image to the page.

Jason Gagnon
FLIR Systems
Technical Support
e-mail: jason.gagnon@flir.com
 
Re:Duplicating a page on the report Brimstone 2/22/2005
You mean like making a second result table besides the original one on the side?
 
Re:Duplicating a page on the report Francky Vereecke 2/22/2005
Create a ' single page ' template and use Word insert file.
 
Re:Duplicating a page on the report Brimstone 2/22/2005
Of course how didn't I think of it. A single page report and then insert

Thanks a bunch
 
Re:Duplicating a page on the report Raphael Danjoux 2/23/2005
Be careful to the procedure suggested by Francky.
Some links are going to disappeared. You'll need to redefine them manually.
 


  • Back to Threads
  • Back to Forums

     

  •   Copyright © FLIR Systems, Inc 2012