| Title | By | Posted On |
| Pillow block |
manuel-thermoimagen |
11/11/2008 |
Pillow block from a Refiner pump on a mill paper plant, image to share, any comments about temperature on pillow block?
|
 |
|
| |
| Re:Pillow block |
rbushee |
11/11/2008 |
| The first think is there grease on the housing in the maked area the grease could be a better emitter, if not I would look to see if there is thinning of the housing in this area and also check the clearence between the housing and the bearing. |
|
| |
| Re:Pillow block |
Lady IR tech |
11/15/2008 |
besure to also check (which I'msure you did) that there is not a reflection from a light source above and to the side of the area. I have seen this several times as a forgotten look back over the shoulder to check.
Otherwise different paint on the pillow block or other substant on it (ie oil, grease, dirt)
|
|
| |
| Re:Pillow block |
manuel-thermoimagen |
11/28/2008 |
the pillow block was nice and clean. no excess grease or oil on it
problem was solved checking bolts Torque, was tighted more on one side.
regards |
|
| |
| Re:Pillow block |
Gary Orlove |
12/3/2008 |
| With different palette applied |
 |
|
| |
| Re:Pillow block |
skid |
12/9/2008 |
| Is it belt driven or direct drive? I had a problem with a pillow block bearing on a fan which was overgreased. The hot spot was on the opposite side away from the belts. If there is too much grease it could be causing the problem although 160 F is a little high but not in the danger zone. |
|
| |
| Re:Pillow block |
manuel-thermoimagen |
12/9/2008 |
skid wrote:
elt driven or direct drive? I had a problem with a pillow block bearing on a fan which was overgreased. The hot spot was on the opposite side away from the belts. If there is too much grease it could be causing the problem although 160 F is a little high but not in the danger zone. Direct Drive Skid, few days before to installation/maintenance, mechanics lost the torquemeter, so, this was tight more one side.
regards |
|
| |
